Cardinal 201 - Page 65

Model 201 Installation & Technical
8400-M117-O1 Rev D
Page 57
 - Computer Output Format 2
If ComP is selected, the data will be transmitted in the following format:
<s><xxxxxx><d><uu><m><cc><cr>
Where:
s =
Sign
"-" = negative
" " (blank) = positive
xxxxxx.xxx =
Weight
Six digits
d =
Decimal point
Added to string if enabled in setup
uu =
Units
lb, kg, oz, g (note lower case units)
m =
Mode
G = Gross, N = Net
cc =
Weight Status
OC = overcap
CZ = center of zero
MO = motion
ee = weight not currently being
displayed
cr =
Carriage Return
(hex 0D)
prnt= (Print from Port)
Press the F3/  key to show the current setting. If the setting displayed
is acceptable, press the F3/  key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/  key to save
it. Allowable settings are:
off
Off (Print from Port is disabled)
tABS
Print using Print Tab Settings
CSu
Print using Comma Separated Values