Cardinal 825 - Application Auto Run Settings; Configuring Auto Run Application; Auto Run Seconds Configuration

8545-M838-O1 Rev D  825 Installation & Technical
112
CONFIGURE APPLICATION MENU, CONT.
Auto run:

With the Configure Menu screen displayed, the current setting for the Auto run:
parameter will be shown. If the setting displayed is acceptable, press the ENTER key or the
Navigation Keys  Left Arrow to return to the previous screen.
Otherwise, press the SPACE key to step through and select the application to auto run
(automatically load and run from the Application Menu screen) and then press the  Down
Arrow to advance to the next parameter or press the ENTER key to save the new setting
and return to the previous screen. Available applications are:
None
Truck / ID Storage
DFC Batcher
Checkweigher
Configuration
File Manager
Transfer
Slide Show
Return to Startup

If an application is selected to “auto run”, an additional parameter (below the Auto run:)
will be shown.
Auto run secs:
With the Configure Menu screen displayed and an application selected to “auto run”, the
current setting for Auto run secs: will be shown. If the setting displayed is acceptable,
press the ENTER key to return to the previous screen.
Otherwise, use the numeric keys to enter the number of seconds before the application
automatically loads and runs (countdown timer on the Application Menu screen) and then
press the ENTER key to save the new setting and return to the previous screen. Supported
countdown times are 2 through 90 seconds.