Cardinal 825 - Input;Output Terminal Connections; 825 Source Power Connections

8545-M838-O1 Rev D  825 Installation & Technical
20
INSTALLATION, CONT.
I/O (Input/Output) Terminal Connections – 825 Source Power
Refer to the table and Figure No. 16 below to connect each wire to the terminal block.
INPUT/OUTPUT – TERMINAL P16 (825 SOURCE POWER)
Terminal
Function
Terminal
Function
1
12v (12VDC from 825)
6
OUT1 (Output 1 @ 100mA MAX.)
2
IN1 (Input 1)
7
OUT2 (Output 2 @ 100mA MAX.)
3
IN2 (Input 2)
8
OUT3 (Output 3 @ 100mA MAX.)
4
IN3 (Input 3)
9
OUT4 (Output 4 @ 100mA MAX.)
5
IN4 (Input 4)
10
GND (Ground)
IMPORTANT!
 Install J1 and J2 to allow the 825 to supply (source) 12VDC to a solid-state relay or other
load (100 mA maximum).
Figure No. 16