8545-M838-O1 Rev D 825 Installation & Technical
OPERATORS, CONT.
1. List Operators
1. With the Setup Operators screen displayed, press the 1 key or use the Navigation Keys
to select (highlight) 1. List Operators and then press the ENTER key.
2. The display will change to show the Operator List screen for the current
programmed operators.
3. After viewing the list, press any key to return to the Setup Operators screen.
2. Add Operator
When you add an operator to the indicator, you are allowing that individual to have access
to functions and features of the indicator.
With the Setup Operators screen displayed, press the 2 key or use the Navigation Keys to
select (highlight) 2. Add Operator and then press the ENTER key. The display will
change to show the Add Operator screen.
Login:
Use the alphanumeric keys to enter a login (name) for the operator (up to 8 characters,
e.g., CARDINAL) and then press the Down Arrow to advance to the next parameter.
Password:
Use the alphanumeric keys to enter a password for the operator (up to 8 characters) and
then press the Down Arrow to advance to the next parameter. Note that if a password
is not required (or desired), it can be left blank. IMPORTANT! The password will be
visible while entering it. During operations, a row of asterisks will be shown when
entering the password.
NOTE: To change the displayed setting on the following parameters, press
the SPACE key to toggle between Yes and No or press the Y key for Yes or
the N key for No.
To Next Page
Loading...
