8545-M838-O1 Rev D 825 Installation & Technical
SET FACTORY DEFAULTS
With the Application Menu displayed, press the U key or use the Navigation Keys to select
(highlight) Configuration and then press the ENTER key. The display will change to show
the Configuration screen.
Set Factory Defaults
With the Configuration screen displayed, press the Dkey or use the Navigation Keys to
select (highlight) Set Factory Defaults and then press the ENTER key. The display
will change to show the Configure Application Menu screen.
ERASE (Y/N)?
With the Set Defaults Warning message displayed, press the Y key to proceed with setting
the indicator back to the factory defaults.
Otherwise, press the N key to return to the Configuration screen.
IMPORTANT: To set the indicator back to the factory defaults, you must type
E R A S E
one letter per screen and then press the ENTER key on the last screen.
NOTE: You can cancel the operation at any time by pressing any other key.
To Next Page
Loading...
