8545-M838-O1 Rev D 825 Installation & Technical
LEAD AND WIRE SECURITY SEAL INSTALLATION
If your Model 825 indicator is used in a commercial application and your local metrology laws
require the use of physical sealing, a lead and wire security seal can be installed to prevent the
rear panel from being removed from the indicator. Refer to the Figure No. 24 for a suggested
location and details on the installation of the security seal.
NOTE: In order to install the lead and wire security seal, two (2) acorn nuts on the
rear panel MUST be replaced with drilled acorn nuts. They are available from the
Cardinal Scale Mfg. Parts Department. The part number is 8200-B026-08 (NUT HEX
#10-32 ACORN SS DRILLED).
Figure No. 24
To Next Page
Loading...
