8545-M838-O1 Rev D 825 Installation & Technical
KEYPAD FUNCTIONS, CONT.
Navigation Keys
The Navigation Keys are used to move around and highlight the soft keys and menu selections
configured by the Standard indicator and Application programs. During setup and calibration,
they are used to select (highlight) the parameter to change and to advance to the next
parameter, backup to the previous parameter or exit” to the previous screen.
Press the Down Arrow key to move “down” to highlight the selection.
Press the UP Arrow key to move “up” to highlight the selection.
Press the Left Arrow key to move “left” to highlight the selection.
Press the Right Arrow key to move “right” to highlight the selection.
ENTER
The Navigation Keys ENTER key is used to select and perform the function of a highlighted
soft key or menu selection.
Note that this key and alphanumeric ENTER key perform the same functions. Either key
can be used when entering or changing data to signal the completion of data entry and
process the data entered. During normal operations (as well as Calibration and Setup),
pressing the key will retain the current settings for the parameters displayed and advance to
next screen.
Alphanumeric Keys
This section describes the alphanumeric keys along with any special functions they have. The
alphanumeric keys are used to enter commands and data into the indicator during normal
operations as well as during Calibration and Setup.
QWERTY KEYS
These keys are used to enter alphabetical characters during Calibration and Setup as well
as during normal operations.
NUMERIC KEYS (1 to 9 and 0)
These keys are used to enter numeric data during the setup and calibration as well as
during normal operation of the indicator. Note that they have alternate meanings. See the
SHIFT and FUNCT keys
To Next Page
Loading...
