8545-M838-O1 Rev D 825 Installation & Technical
INSTALLATION, CONT.
Re-Installing the Rear Panel
After all terminations have been made;
1. Reinstall the 825-SIB into the enclosure, taking care not to strike the board against the side
of the 825 enclosure (see Figure No. 18 below).
2. Secure the 825-SIB to the main PC board with the screw removed earlier.
3. Remove the excess cable from the indicator enclosure and securely tighten each of the
cable gland connectors.
Do not over-tighten these connectors but make certain they are snug.
DO NOT USE TOOLS! Finger-tighten only!
4. Ensure any unused gland connectors are plugged and replace the rear panel.
5. Secure the rear panel with the 14 acorn nuts removed earlier.
6. Follow a diagonal pattern when tightening the acorn nuts.
Secure 825-SIB
to main board
by installing
this screw.
CAUTION!
When installing 825-SIB, be
careful not to strike board
against side of 825 enclosure.
To Next Page
Loading...
