EasyManua.ls Logo

Cardinal 825 - Instrument Precautions and Safety; Static Electricity Handling

Cardinal 825
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8545-M838-O1 Rev D 825 Installation & Technical
7
PRECAUTIONS
Static Electricity
CAUTION! This device contains static sensitive circuit cards and components.
Improper handling of these devices or printed circuit cards can result in damage to or
destruction of the component or card. Such actual and/or consequential damage IS
NOT covered under warranty and is the responsibility of the device owner. Electronic
components must be handled only by qualified electronic technicians who follow the
guidelines listed below:
ALWAYS handle printed circuit card assemblies by the outermost edges. NEVER
touch the components, component leads or connectors.
ALWAYS observe warning labels on static protective bags and packaging and
NEVER remove the card or component from the packaging until ready for use.
ALWAYS store and transport electronic printed circuit cards and components in anti-
static protective bags or packaging.
ATTENTION! ALWAYS use a properly grounded wrist strap when handling,
removing or installing electronic circuit cards or components. Make certain that the
wrist strap ground lead is securely attached to an adequate ground. If you are
uncertain of the quality of the ground, you should consult a licensed electrician.

Table of Contents

Related product manuals