Cardinal 825 - Page 88

8545-M838-O1 Rev D  825 Installation & Technical
82
OPERATORS, CONT.
Zero:
With the Add Operator screen displayed, the current setting for Zero: will be shown. If
the operator is allowed to zero the scale, press the  Down Arrow to proceed to the next
parameter.
Otherwise, press the SPACE key (or the Y or N key) to toggle between the Yes and No
and then press the  Down Arrow to advance to the next parameter.
Keybd tare:
With the Add Operator screen displayed, the current setting for Keybd tare: will be
shown. If the operator is allowed to manually enter a tare weight, press the  Down
Arrow to proceed to the next parameter.
Otherwise, press the SPACE key (or the Y or N key) to toggle between the Yes and No
and then press the  Down Arrow to advance to the next parameter.
Push tare:
With the Add Operator screen displayed, the current setting for Push tare: will be
shown. If the operator is allowed to use the Push Button tare function to enter a tare
weight, press the  Down Arrow to proceed to the next parameter.
Otherwise, press the SPACE key (or the Y or N key) to toggle between the Yes and No
and then press the  Down Arrow to advance to the next parameter.
Print:
With the Add Operator screen displayed, the current setting for Print: will be shown. If
the operator is allowed to print a ticket, press the  Down Arrow to proceed to the next
parameter.
Otherwise, press the SPACE key (or the Y or N key) to toggle between the Yes and No
and then press the  Down Arrow to advance to the next parameter.
Units:
With the Add Operator screen displayed, the current setting for Units: will be shown. If
the operator is allowed to select the alternate weighing units, press the  Down Arrow to
proceed to the next parameter.
Otherwise, press the SPACE key (or the Y or N key) to toggle between the Yes and No
and then press the  Down Arrow to advance to the next parameter.
Sel Scale:
With the Add Operator screen displayed, the current setting for Sel Scale: will be
shown. In a multiple scale operation, if the operator is allowed to choose between
available scales, press the  Down Arrow to proceed to the next parameter.
Otherwise, press the SPACE key (or the Y or N key) to toggle between the Yes and No
and then press the  Down Arrow to advance to the next parameter.