Cardinal 825 - Page 147

To Next Page

To Previous Page

8545-M838-O1 Rev D  825 Installation & Technical

141

PART IDENTIFICATION

(Rear – Inside View)

NOTE: The ground wire for the power supply is attached to the enclosure wall at the

ground lug located under the power supply housing as show.

Main Page

Default Chapter3
- Table of Contents3
Introduction7
Fcc Compliance Statement8
Proper Disposal8
Specifications9
Features10
Application Software Used in Trade11
European Declaration of Conformity12
Precautions13
- Static Electricity13
Site Preparation14
- Environmental14
- Electrical Power15
- Electrical Noise Interference15
- Transient Suppression15
Installation16
- Mounting the 82516
- Load Cell Cable Connection with RFI Suppression17
- Load Cell Cable Connection Without RFI Suppression20
- Load Cell Connections with over 30 Feet of Cable21
- 825-SIB (Scale Input Board)21
- I/O Cable Preparation and Installation22
- RS232 Terminal Connections22
- 20Ma Terminal Connections24
- RS485 Terminal Connections25
- I/O (Input/Output) Terminal Connections - 825 Source Power26
- I/O (Input/Output) Terminal Connections - External Power Source27
- Re-Installing the Rear Panel28
Main Pc Board29
- Jumpers30
- Connectors31
- Status Led's32
Keypad Functions33
- Navigation Keys34
- Alphanumeric Keys34
- Standard Indicator Keys36
- Touch Screen Keys39
Annunciators42
Setting the Date and Time43
Setup and Calibration44
- Calibration Inhibit Jumper44
- To Begin Setup and Calibration47
  - Setup Menu49
Preferences82
- Date/Time82
- Sound Settings85
Operators86
- List Operators87
- Add Operators87
- Edit Operators90
- Delete Operators93
- Set Default Operators94
Configuration95
- To Begin Configuration95
Ticket Settings107
- Print Tab Setting109
Configure Application Menu116
- Enable/Disable Menu Items116
Set Factory Defaults119
Application Menu Screen122
Troubleshooting123
- Weight Status Messages123
  - Displayed Concurrently with Weight123
  - Displayed in Place of Weight123
- Operation Messages123
  - Momentarily Displayed after Operator Attempts an Action123
- Error Codes125
- Before You Call Service126
Diagnostics127
- Startup Screen127
- To Begin Diagnostics128
Fine Span Adjustment131
Event Counters134
- To View the Event Counters134
Certifications / ID Information136
- To View the Certifications / ID Information136
Electronic Talley Roll (Etr) File138
- To View the Electronic Talley Roll (ETR) File138
Lead and Wire Security Seal Installation142
Part Identification143

Cardinal 825 - Page 147

Table of Contents

Related product manuals