8545-M838-O1 Rev D 825 Installation & Technical
KEYPAD FUNCTIONS, CONT.
Touch Screen Keys, Cont.
ZERO
This key allows the operator to reset the Gross weight to zero. IMPORTANT! If the gross
weight exceeds the zero limit for this key, pressing this key will momentarily display the
message:
CANNOT ZERO –
The display will return to the Weight screen, showing gross weight only
Note that the zero limit may be either 4% or 100% of the scale capacity. This limit is set
during setup and calibration (see the Zero Limit parameter).
TARE (Pushbutton Tare)
Pressing this key will act as a pushbutton tare and will store the current Gross weight as the
new tare weight and will switch the display to the Net weight mode.
UNITS
Pressing this key will change the weighing units to the alternate units if available. For
example, with lb (pounds) showing, pressing this key will change the weight units to kg
(kilograms). IMPORTANT! This feature must be enabled during setup and calibration (see
the Base Units and Conv Units parameters).
PRINT
Pressing this key will initiate the transmission of weight data to the ticket printer. If
displaying Gross weight, the time, date and gross weight are printed. If displaying net
weight, the time, date, gross, tare and net weights are printed. IMPORTANT! If the weight
is less than zero (negative weight), pressing this key will momentarily display the message:
Cannot print BELOW ZERO –
The display will return to the Weight screen, showing gross weight only. Also, if the weight
is unstable (motion on the scale), pressing this key will momentarily display the message:
Cannot print MOTION –
The display will return to the Weight screen, showing gross weight only
To Next Page
Loading...
