8545-M838-O1 Rev D 825 Installation & Technical
SETUP AND CALIBRATION, CONT.
Press the Navigation Keys Down Arrow or UP Arrow to (highlight) the 3.Setup menu
option and then press the ENTER key or press the 3 key to select the 3. Setup menu
option. The display will change to show the login and password prompt screen.
1. With the Login screen and prompt displayed, use the alpha-numeric keys to enter the
login and then press the Down Arrow to advance to the password prompt
2. Enter the password using the alphanumeric keys and then press the ENTER key to
proceed with Calibration and Setup.
NOTE: The 825 will arrive from the factory with the calibration access locked by the
“login” and “password” prompts protection. The factory default login and password
are “ADMIN” and “81440”.
To Next Page
Loading...
