8545-M838-O1 Rev D 825 Installation & Technical
OPERATORS, CONT.
Login:
With the Edit Operator screen displayed, the current login (name) will be shown. If the
login displayed is acceptable, proceed to the next parameter.
Otherwise, use the alphanumeric keys to enter a new login for the operator (up to 8
characters) and then press the Down Arrow to advance to the next parameter.
NOTE: Changing the login REPLACES the current login. It DOES NOT create
a new login in addition to existing login. It will however, retain the settings from
the old login for the new login (e.g., Zero: Yes, Keybd tare: No, etc...).
Password:
With the Edit Operator screen displayed, the current password will be shown. If the
password displayed is acceptable, proceed to the next parameter.
Otherwise, use the alphanumeric keys to enter a new password for the operator (up to 8
characters) and then press the Down Arrow to advance to the next parameter. Note
that if a password is not required (or desired), it can be left blank. IMPORTANT! The
password will be visible while entering it. During operations, a row of asterisks will be
shown when entering the password.
NOTE: To change the displayed setting on the following parameters, press
the SPACE key to toggle between Yes and No or press the Y key for Yes or
the N key for No.
Zero:
With the Edit Operator screen displayed, the current setting for Zero: will be shown. If
the setting displayed is acceptable, proceed to the next parameter.
Otherwise, press the SPACE key (or the Y or N key) to toggle between the Yes and No
and then press the Down Arrow to advance to the next parameter.
Keybd tare:
With the Edit Operator screen displayed, the current setting for Keybd tare: will be
shown. If the setting displayed is acceptable, proceed to the next parameter.
Otherwise, press the SPACE key (or the Y or N key) to toggle between the Yes and No
and then press the Down Arrow to advance to the next parameter.
Push tare:
With the Edit Operator screen displayed, the current setting for Push tare: will be
shown. If the setting displayed is acceptable, proceed to the next parameter.
Otherwise, press the SPACE key (or the Y or N key) to toggle between the Yes and No
and then press the Down Arrow to advance to the next parameter.
To Next Page
Loading...
