151
3.9 Clerk Operation
There are three clerk modes as below.
▶ Clerk Modes
No. Clerk Modes Description
1 No Clerk
Sales clerk does not log in and makes sales using “PRINT” key.
2 Standard Clerk
Generating a standard clerk transaction is the same as any sales
mode transaction except that you do NOT press the PRINT key;
instead you must press one of the V(Clerk-Speed) keys (1
through 4)
You can print total price label depending on the setting.
3 Floating Clerk
Generating a standard clerk transaction is the same as any sales
mode transaction except that you do NOT press the PRINT key;
instead you must press one of the V(Clerk-Speed) keys (1
through 4)
You can print total price label depending on the setting. Sales
data is added automatically.
☞ To register clerk, refer to menu code 1850 of program mode. (See chapter 2.14.6)
Assumption
- Clerk should be registered on menu 1850. (See chater 2.14.6)
- Clerk number should be set on menu 1856 to use “V1, V2, V3, and V4” keys (See chapter
2.14.12) If the clerk is not assigned to V1~V4, this clerk has to enter password after pressing
V key.
- All clerks can use “V” key.
* Up to 100 transactions are available in Clerk mode
* Sales data is saved in memory.
* If you press PRINT key to complete transaction, grand total price is printed and sales data is
cleared from memory.
* If you want to see total price before completing transaction, press the ST/TTL key. To print,
press the PRINT key.
* Even though you turn off the scale before printing, sales data is not cleared.
* If you want to print ticket when you log out, press V1, V2, V3 or V4 to log on and press the
PRINT key. You can also check total price by pressing ST/TTL key after log on.
To Next Page
Loading...
Need help?
General
