74
2.6 Speed Key Setting
This menu is to set “speed keys”, one-touch keys, for most frequently used PLUs to
simply call up them. You can program up to 5 speed key set. Remember that there is a
SHIFT key that allows you to double-use the Speed Keys. The Speed keys are
numbered left-to-right and top-to-bottom.
You can use speed key set number when you program menu 1211.(See chapter 2.2.2)
☞ User can not assign the function key as speed keys.
2.6.1 Speed Key (Menu code 1160)
(MENU -> 1.PLU -> 6.Speed Key)
1. Speed Key Set No.
Enter speed key set no. You can use this number when you
program menu 1211. (See the chapter 2.2.2)
EX) Speed key set No. = 2
SPEED KEY (2/2)
Speed Key No : [ 1]
PLU No : [ 0]
2. Speed Key Programming
The Speed keys are numbered left-to-right
and top-to-bottom. In case of standard type,
there are 8 columns and 6 rows for a total of 48
physical keys but if you press the SHIFT key and
then one of the 48 Speed keys, then you can
access Speed keys 49 through 96. In case of
pole type, there are 72 keys but if you press the
SHIFT key and then one of the 72 Speed keys,
then you can access Speed keys 73 through 144.
EX1) Speed key no. 1
EX2) Speed key no. 49
(In case of standard type)
SPEED KEY (1/2)
Speed Key Set No: [ 2]
SPEED KEY (2/2)
Speed Key No : [ 49]
PLU No : [ 0]
A
2. PLU No.
Enter PLU no. to assign speed key
* PLU should be belong to scale’s department.
EX1) PLU 10 = BEEF
SPEED KEY (2/2)
Speed Key No : [ 1]
PLU No : [ 10] BEEF
PRINT
0
PRINT
1
A PRINT
SHIFT
PRINT
2