CAS CL5000 Series - 2.10 Programming Cutting Hall

79
2.9.3 List Slaughter House (Menu code 1352)
(MENU -> 3. PLU Data Table II -> 5.Slaughter house -> 2. List )
※ If you want to print list, press the TEST key.
2.9.4 Delete Slaughter House (Menu code 1353)
(MENU -> 3. PLU Data Table II -> 5.Slaughter House -> 3. Delete )
2.10 Programming Cutting Hall
2.10.1 Cutting Hall (Menu code 1360)
(MENU -> 3. PLU Data Table II -> 6.Cutting Hall)
You can use this cutting hall data when you program traceability.
2.10.2 New/Edit Cutting Hall (Menu code 1361)
(MENU -> 3. PLU Data Table II -> 6.Cutting Hall -> 1. New/Edit )
※ You can press the SAVE key at anytime to save the current data and if you want
to exit without saving, press the ESC key.
1. Set the list range
Enter list range to check
EX) 1~10
LIST SLAUGHTER HOUSE (1/1)
- Start Number : [ 1]
- End Number : [ 10]
List All – press [SAVE] key
PRINT
1
PRINT
0 1
1. Enter slaughter house number to delete
EX) Delete slaughter house no. 1
DELETE SLAUGHTER HOUSE (1/1)
Enter Slaughter House No : [ 1]
PRINT
1
1. Enter cuttting hall number
This value can be from 1 to 99
EX) Cutting hall no. = 1
PRINT
1
NEW/EDIT CUTTING HALL (1/1)
EnterCutting Hall No. : [ 1]
Hall : [ ]
Country : [ 0]