Cellwatch Frontier System Installation & User Manual
Section I – Installation Guide-48
When installing the post clip, take care to not push off any battery grease that might be on the side of
the posts. The no-ox or battery grease creates an effective barrier against corrosion of the post. The
best way to achieve this is to ‘hook’ one side of the post clip and then use an insulated flathead
screwdriver in the available slot to ‘pull’ the other side of the clip over the post. While holding slight
pressure to hold the clip open, move the clip down to rest on the top of the post. Use any size
screwdriver that fits into the slot (example, ¼ inch).
Installing a Post Clip using Screwdrivers
Front View of Installed Post Clip
To Next Page
Loading...