Chapter 1 – What the Illuminator Does
Section 1.6 – Warnings
1-10
Chapter 7: SPECIFICATIONS
WARNING
The use of accessories and cables other than those specified
in this manual, as replacement parts for internal
components, may result in increased emissions or decreased
immunity of the illuminators.
Section 7.2 - Illuminator Compliance with Standards
WARNING
The illuminators should not be used adjacent to or stacked
with other manufacturer’s equipment. If adjacent or stacked
use is necessary, the illuminators should be observed to
verify normal operation in the configuration in which it will
be used.
Section 7.2 - Illuminator Compliance with Standards
WARNING
The pins of connectors identified with the ESD warning
symbol should not be touched and connections should not be
made to these connectors unless ESD precautionary
procedures are used.
Precautionary procedures include:
• methods to prevent build-up of electrostatic charge
(e.g. air conditioning, humidification, conductive
floor coverings, non-synthetic clothing);
• discharging one’s body to the frame of the
EQUIPMENT or SYSTEM or to earth or a large
metal object;
• bonding oneself by means of a wrist strap to the
EQUIPMENT or SYSTEM or to earth.
Section 7.2 - Illuminator Compliance with Standards
WARNING
The illuminator must be attached to the mains and grounded
to comply with appropriate standards.
Section 7.3 - Illuminator Requirements
To Next Page
Loading...