Chapter 7 – Specifications
Section 7.3 – Illuminator Requirements
7-5
Guidance and Manufacturer’s Declaration – Electromagnetic Immunity
The INT100 illuminator has been tested and found to comply with the limits of the
standard for control, measurement, and laboratory equipment IEC 61326-1. The
unit also complies with the requirements of the 61326-1 standard, providing the
presumption of compliance to the European Union’s EMC Directive
200/95/EC. The limits are designed to provide reasonable protection against
harmful interference in a typical installation. This equipment generates, uses,
and can radiate radio frequency energy, and, if not installed and used in
accordance with the manufacturer’s instructions may cause harmful
interference to other devices in the vicinity. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment causes
interference with other devices, which may be determined by turning the
equipment off and on, the user is encouraged to try and correct the interference
by one or more of the following measures:
• Reorient or relocate the device receiving the interference.
• Increase the separation between the equipment.
• Connect the equipment into an outlet on a circuit different from that to which
the other device(s) are connected.
• Consult the manufacturer or field technical service representative for help.
CAUTION
The illuminators need special precautions regarding electromagnetic
compliance (EMC) and need to be installed and put into service
according to the EMC information provided above.
CAUTION
Portable and mobile radio frequency (RF) communications equipment
can affect the illuminators by interfering with the electronics, causing the
illumination to stop.
WARNING
The use of accessories and cables other than those specified in this
manual, as replacement parts for internal components, may result in
increased emissions or decreased immunity of the illuminators.
WARNING
The illuminators should not be used adjacent to or stacked with other
manufacturer’s equipment. If adjacent or stacked use is necessary, the
illuminators should be observed to verify normal operation in the
configuration in which it will be used.
WARNING
The pins of connectors identified with the ESD warning symbol should not
be touched and connections should not be made to these connectors
unless ESD precautionary procedures are used.
Precautionary procedures include:
methods to prevent build-up of electrostatic charge (e.g., air
conditioning, humidification, conductive floor coverings, non-synthetic
clothing);
discharging one’s body to the frame of the EQUIPMENT or SYSTEM or to
earth or a large metal object;
bonding oneself by means of a wrist strap to the EQUIPMENT or SYSTEM or
To Next Page
Loading...