CESAB S210 - Page 132

© Cesab 8 – 32 T Code(s): 841, 842, 843
Repair manual: Troubleshooting Model(s): S210, S212, S212S, S212L, S214, S214L, S220D
Publication Number: 7588857-040 Date: 2018-05-01 Applies from serial number: 6384351-
3:590
The change
exceeds 1000 rpm
in 20 ms
The drive is
stopped
immediately with
the parking brake
1: Broken wiring
2: Defective
component
3: Change in
surface friction
combined with
slippage
1: Check wiring after the break.
• Disconnect the battery
• Using instruments, check that
there is no break in any wire.
• Measure and check the voltage
with the functions activated
2: Check the rotational speed
sensor
• Disconnect the B11. Check that
there are no metal fragments on
B11 sensor points.
• Check that the toothed wheel on
the motor axle is clean, intact
and properly mounted.
3: Drive carefully if there is a risk
of slipping
3:592
Internal electrical
fault.
Sensor offset is too
high
The drive is
stopped
immediately with
the parking brake
1: Defective
motor control
1: Replace T1
Code Description
Truck
behaviour
Error cause(s) Procedure
https://www.forkliftpdfmanuals.com/