Check Point HARMONY R81 - Page 182

Active Directory Authentication
R81 Harmony Endpoint Server Administration Guide|182
To see full debugging information in the Authentication.log file on an Endpoint Security
server:
1. On the Endpoint Security server, run:
export TDERROR_ALL_KERBEROS_SERVER=5
2. Restart the Endpoint Security server. Run:
uepm_stop ; uepm_start
Results in Authentication.log
n
If the Authentication.log file on the server shows:
ERROR: Config file contains no principals
The database was cleaned or the process to include authentication in the client package
was faulty. To fix:
1. Repeat the process to configure Active Directory authentication (See "Configuring
Active Directory Authentication" on page177 ).
2. Make a new client package.
3. Restart the Endpoint Security server:
reboot
n
If the Authentication.log file on the server shows:
Permission denied in replay cache code
Restart the Endpoint Security server:
reboot
n
If the Authentication.log file on the server shows:
Clock skew too great
l
Make sure that the Endpoint Security Management Server and all clients are
synchronized with the Active Directory server.