Configuring Application Permissions in the Application Control Policy
R81 Harmony Endpoint Server Administration Guide|378
Configuring Application Permissions in the
Application Control Policy
In the Application Control Policy, review the permissions for applications for each application
and application version.
For applications and application versions that you are know are secure, change the permission
setting to Allow .
If you know the applications or application versions are not secure, change the permission
setting to Block.
You can also configure that blocked applications will be
terminated
when they are started, or
when they try to establish a network connection.
To review the policy settings for applications and application versions:
1. In the Policy tab > Application Control rule, right-click the Allow Applications Action and
select Manage All Applications
2. The Product Rules section shows the details for each product, and the Permission for
each:
Permission Explanation
Unidentified
(Allow)
The application is allowed because the setting for applications that
are imported from the Appscan XML.is
Allow unidentified applications, and the application has not been
configured by the administrator as Allow or Block.
Unidentified
(Block)
The application is allowed because the setting for applications that
are imported from the Appscan XML.is
Block unidentified applications, and the application has not been
configured by the administrator as Allow or Block.
Allow The application has been explicitly configured by the administrator
to be allowed. This setting overrides the classification of the
Reputation Service of an application.
Block The application has been explicitly configured by the administrator
to be blocked. This setting overrides the classification of the
Reputation Service of an application.
Terminate The application is terminated when it tries to access the network or
immediately when it runs.
To Next Page
Loading...
