Check Point HARMONY R81 - Creating a Device Manually; Editing Device Access Setting

Defining Exceptions for Devices
R81 Harmony Endpoint Server Administration Guide|260
Creating a Device Manually
You can manually define a device that was not inserted into a client computer.
To manually create a new device:
1. Open the Storage Devices Read Access, Storage Devices Write Action, or Peripheral
Devices Access action.
2. In the lower section of the Edit Properties window, click Add device.
3. In the Device Override Settings window, select Create a new device.
4. Click Next.
5. Select Manually configure device.
6. Click Next.
7. Enter the device details. "Editing Device Details" on page258
8. Click Next.
9. Optional: Add this device to one or more device groups (storage devices only).
10. Define the behavior of the device. The options shown are based on which action you are
editing:
n
For Storage Devices Write Access see "Configuring a Write Action" on page252
n
For Storage Device Read Access see "Configuring the Read Action" on page251 .
n
For Peripheral device access:
l
Access type: Block or Allow
l
Log type: Log or None
11. Click Finish.
Editing Device Access Setting
You can change the settings for an individual device or category of devices.
To change the access settings for existing devices from the Policy Rule Base:
1. Open the Storage Devices Read Access, Storage Devices Write Action, or Peripheral
Devices Access action.
2. In the Device Overrides area of the Edit Properties window, select a device or group
and click Edit device.