Check Point HARMONY R81 - Compliance Status Reports

Compliance Status Reports
R81 Harmony Endpoint Server Administration Guide|65
Compliance Status Reports
n
Compliance Status - Shows endpoint compliance policies that make sure:
l
The correct version of Endpoint Security is installed.
l
The operating system includes all required updates and service packs.
l
Only approved software applications are installed.
If a user or computer is in violation of a rule, the name of the rule is shown in the
Compliance Violations column. Names of custom rules are also shown.
n
Top Violations - Shows the top compliance violations.
These compliance statuses are used in the reports:
n
Compliant - The computer meets all compliance requirements.
n
About to be restricted - The computer is not compliant and will be restricted if steps are
not done to make it compliant. See "Configuring the "About to be Restricted" State" on
page371 .
n
Observe - One or more of the compliance rules that is set as Observe is not met. Users
do not know about this status and have no restrictions.
n
Restricted - The computer is not compliant and has restricted access to network
resources.
n
Warn - The computer is not compliant but the user can continue to access network
resources. Do the steps necessary to make the computer compliant.
n
Not Running
n
Status information is missing
n
Not installed - The network protection is disabled or not installed.