Check Point HARMONY R81 - Logging into Smartendpoint

Logging Into SmartEndpoint
R81 Harmony Endpoint Server Administration Guide|54
Logging Into SmartEndpoint
1. Install an on-premises Endpoint Security Management Server.
See the R81 Installation and Upgrade Guide > Chapter Installing an Endpoint Server >
Section Installing an Endpoint Security Management Server .
2. Connect with SmartConsole to the Endpoint Security Management Server.
3. Enable the required Software Blade:
a. From the left navigation panel, click Gateways & Servers.
b. Open the Endpoint Security Management Server object.
c. On the Management tab, select Endpoint Policy Management
Note -It is not supported to disable Endpoint Policy Management on a
Security Management Server
d. Click OK.
4. Install the database:
a. Click Menu > Install database.
b. Select all objects.
c. Click Install.
d. Click Close.
5. Open the SmartEndpoint Client:
a. In the top-left corner of SmartConsole, click Menu.
b. Select SmartEndpoint.