Push Operations
R81 Harmony Endpoint Server Administration Guide|63
In the top pane:
n
See all recent Push Operation activities, and their details. This includes: which objects
were included in the operation, the status.
n
Create new, Abort (stop), and Remove Push Operations.
n
Click Configure Defaults to configure the default settings for a selected operation.
These settings will apply each time you run Push Operations and do not configure
different settings.
In the Endpoint List:
See the results of the operations on each endpoint.
You can also start Push Operations from everywhere in the SmartEndpoint where an object is
shown. This includes reports in the Reporting tab and in the Users and Computers tab.
Starting Push Operations
To start Push Operations from an object in SmartEndpoint
1. Right-click an object (user or computer) and select a component, and then an operation.
2. Click Yes to confirm that you want to do the operation.
3. Optional: Click Advanced Settings to use settings that are not the default.
To start Push Operations from Reporting > Push Operations:
1. In Reporting > Push Operations, click Create new.
2. Select a component and an operation.
3. Click Next.
4. Select an OU, node, or computer to get the operation.
5. Click Next.
6. Configure the settings for the operation.
7. Click Next.
8. Click Finish.
To start Push Operations from Users and Computers > Global Actions
In Users and Computers > Global Actions, click Push Operation.
The Create Push Operation wizard opens.
To Next Page
Loading...
