Check Point HARMONY R81 - Getting Licenses

Endpoint Security Licenses
R81 Harmony Endpoint Server Administration Guide|50
n
You can remove a client license by resetting the client or deleting the client using
SmartEndpoint. These licenses are returned to the license pool.
n
Each client gets its Container and Endpoint Security component licenses from a pool of
available licenses.
n
You can combine licenses to reach the total number of required clients.
n
License validation occurs when the client sends a SYNC or heartbeat messages to the
server.
Getting Licenses
This procedure assumes that you have a user account for the Check Point User Center, and
that the necessary licenses and contracts are purchased.
To get the license for your Endpoint Security Management Server:
1. Log in to Check Point User Center .
2. Click My Products > My Products Center.
The page shows the purchased licenses.
Endpoint Security licenses have these parts in the SKU:
n
CPEP - Check Point Endpoint Security containers.
n
CPSB - Check Point component. If the macro string includes the -SUBSCR suffix,
you must get and apply a contract for this feature. See "Getting and Applying
Contracts" on the next page .
3. For each license:
a. Click the license to open it.
b. In the window that opens, click License.
4. Fill in the form that opens.
n
Make sure that Version is R80 or higher.
n
Make sure that the IP Address is the IP address of the Endpoint Security
Management Server.
5. Click License.
A window opens, showing the license data.
6. Save the license file.
7. Add your licenses using one of these methods: