Check Point HARMONY R81 - Opening Smartendpoint; Policy Tab

Using SmartEndpoint
R81 Harmony Endpoint Server Administration Guide|56
n
Malware Infections - Shows which endpoint computers are malware-free, have not been
scanned, or have malware problems.
n
Compliance Verification - Shows which endpoint computers are compliant with the
security policy and which are restricted or have pending warnings.
n
Bot Detections - Shows which endpoint computers have bot problems.
For each category you can see:
n
Trend tab - A line chart that shows the trend over time.
n
Endpoints tab - A table that shows Endpoint computers in greater detail.
You can also click the Getting Started link to run the Endpoint Security Express Setup
Wizard. Do the steps in the wizard pages to quickly configure the default policy for each
component. The wizard also lets you run the "Active Directory Scanner" on page93 and
configure "Uploading Client Packages to the Repository" on page103 .
Opening SmartEndpoint
You can open SmartEndpoint in these ways:
n
Go to Start > All Programs > Check Point SmartConsole <Version> > SmartEndpoint
<Version>.
n
Open SmartConsole, and from the Menu, select SmartEndpoint.
Policy Tab
You define and manage the policy for each Endpoint Security component in the Policy tab.
The policy tab contains the Policy Management Toolbar and the Policy Rule Base.