Check Point HARMONY R81 - Using Capsule Docs

Capsule Docs
R81 Harmony Endpoint Server Administration Guide|288
b. In the Email Server Settings window select User authentication is required.
Configure these parameters:
n
Port - Leave the default (25).
n
User Name -Enter a fictitious email address. This address will show as the
sender of email alerts.
n
Password -Enter a fictitious password. This is not used.
c. Optional: Trigger an alert to test the email server.
6.
Configure Single Sign-On with Active Directory
For managed clients to seamlessly authenticate to Capsule Docs with users' AD
credentials, enable Single Sign-On with Active Directory authentication.
The default setting is Do not allow Single Sign-On with Active Directory.
To enable Single Sign-On with Active Directory:
a. Prepare the Active Directory server for authentication. Use the instructions in
"Configuring Active Directory Authentication" on page177 .
b. Configure the authentication settings in SmartEndpoint. Use the instructions in
"Step 2 of 3: Configuring Authentication Settings" on page179 .
To enable Capsule Docs Single Sign-On, it is not necessary to select Work in
authenticated mode.
>
Best Practice - We recommended that you do not select this option
during the evaluation and lab stage.
c. Save.
d. In SmartEndpoint, Policy tab, in the Capsule Docs policy rules, select Allow
Single Sign-On with Active Directory.
e. Install policy in SmartEndpoint.
Using Capsule Docs
When users create a new document in a supported application, the protection settings of their
default Capsule Docs community are applied to the document. Users can change the settings
through the Capsule Docs menu.
In some MS Office versions, the menu shows in the upper-right corner of documents. In others
it shows in the Home tab.
Based on the Capsule Docs policy that you configure, users can: