Check Point HARMONY R81 - Editing Pre-Boot Users

Editing Pre-boot Users
R81 Harmony Endpoint Server Administration Guide|429
Editing Pre-boot Users
To edit offline Pre-boot accounts:
1. From the Users and Computers tab, expand an Offline Group to see the users .
2. Right-click the user and select User Authentication (OneCheck) > Pre-boot
Authentication method.
3. Select an Authentication Method.
4. Click Change Password or User Certificates to create a new password or upload
certificates, as required for the authentication method.
5. Click OK.
To edit a deployment Pre-boot account:
1. From the Users and Computers tab, open Offline Groups.
2. Select the preboot user account
3. Select Deployment Pre-boot User Details and click Edit.
To create offline Pre-boot users
1. From the Users and Computers tab, select an offline group.
2. In Group Details, click Edit.
The Group Details window opens.
3. Click Pre-boot Users.
The Pre-boot Users Details window opens.
4. In the Authorized Preboot Users area, click New.
The Add new preboot user window opens.
5. Enter a Logon Name
6. In the Authentication credentials area, select Password or Dynamic Token.
n
A password must contain at least five characters
n
If you select a token as the authentication method, make sure you select an
existing token
7. To set more granular account controls, open Account Details.
In Account Details you can configure the type of use and expirations settings.