Check Point HARMONY R81 - Push Operations Settings

Push Operations
R81 Harmony Endpoint Server Administration Guide|64
Push Operations Settings
Click Configure Defaults to configure the default settings for a selected operation. These
settings will apply each time you run Push Operations and do not configure different settings.
Select the operation to configure.
For each operation you can configure:
n
User Notification -Are users notified about the operation and can they cancel or
postpone it. The options are:
l
Execute operation immediately - Users cannot cancel or postpone it.
Optional: Select Inform user and click Configure to configure a notification message that
users see and in how many minutes the operation will occur. If you do not select Inform
user, the operation runs silently.
l
Allow user to postpone or cancel operation - Users can cancel or postpone it.
Click Configure to configure the notification message that users see and in how
many minutes the operation will occur.
n
Scheduling - When does the operation occur. The options are:
l
Execute operation immediately
l
Schedule operation for - Enter a date and time when the operation will start.
n
Timeframe - The Endpoint Security Management Server will send the operation to
clients for the selected number of hours.
For Anti-Malware Push Operations, see "Configuring Anti-Malware Policy Rules" on page299 .