Capsule Docs
R81 Harmony Endpoint Server Administration Guide|283
n
Enable the Mobile Access component on the Security Gateway.
n
Configure the Reverse Proxy on the Security Gateway or server to point to the
Endpoint Security Management Server.
Note - Make sure the name of the Endpoint Security Management Server
resolves correctly in DNS.
n
For Gaia: If the Gaia Portal of the Mobile Access Security Gateway is on
https://<
IP Address of Security Gateway
>/ with a "/" at the end and on TCP
port 443, you must change the URL or port.
For example, change the URL to https://<
IP Address of Security
Gateway
>/gaia or change the TCP port to 4434.
Change the URL in the Gateway Properties tree select Platform Portal and
change the Main URL.
This change requires a policy installation.
If you do not make this change, the Gaia Portal is not accessible.
To enable the Mobile Access component on the Security Gateway:
a. In SmartConsole, double click the Security Gateway object.
b. In the properties window that opens, select Mobile Access in the components
section.
The Mobile Access Configuration wizard opens.
c. Click Cancel, if you want to use the Security Gateway as a reverse proxy only.
The Mobile Access Policy is created, but has no rules in it.
d. Click OK.
e. In the main menu, go to Policy > Install.
f. Select the Security Gateway to install policy only on the Security Gateway.
During policy installation, a warning shows: The Mobile Access Policy does not
contain any rules. You can ignore this.
g. Click OK.
To Next Page
Loading...
