Configuring Offline Mode
R81 Harmony Endpoint Server Administration Guide|422
d. Select a Category. Each category has a default path under the defined root
path. Keep the default or click Add, Edit, or Remove to change the path or add a
new one.
e. Click OK.
f. Select a value for each of the Synchronization Settings:
n
Clients sync with shared location every X minutes
n
After a failed connection, clients retry to sync with shared locations
every X minutes
n
Clients stop trying to sync with shared location after X failed attempts -
This is only active when selected.
g. Click Next to configure the Policies for the group.
2.
Configure a Policy for each Component of the Offline Group
Configure a Policy for each Endpoint Security client component:
Authorize Pre-boot Users
Continue with the New Offline Group wizard or click Authorize Pre-boot Users to
configure the users who can log in to computers in the offline group.
n
Click Add to add an authorized user
n
Click Remove to remove a use
Note - Removing a user from the Authorized Pre-boot user list will not remove
the user from an already installed client. Use the Blocked Users feature to
remove users on clients.
n
Click Show all users to show the complete list
n
Enter text in the Search field to search the list of users
n
Click Blocked Users to create a list of users who are blocked from all computers
in the offline group
Note - Smart Card authentication is not supported for Offline Pre-boot users. Select
password or dynamic token as the authentication method.
Full Disk Encryption Policy
Continue with the New Offline Group wizard or click Full Disk Encryption to configure
the Full Disk Encryption policy settings for the group.
To Next Page