Check Point HARMONY R81 - Page 425

Configuring Offline Mode
R81 Harmony Endpoint Server Administration Guide|425
Option Description Notes
Deployment >
Get Offline to
Online File
Exports a file that converts an offline
client to an online client. After
installation, the client will connect to
the server that the file was exported
from.
You must put the
CPPOL file in the
Updates folder.
For best practices,
see "Moving from
Offline to Online
Mode" on page431
To export all offline administrators:
a. Right-click on an offline group and select Get Offline Management File (cpomf)
or
b. Select multiple administrators in an Administrator OU under an offline group,
right-click, and select Get Offline Management File (cpomf).
To replace the installation policy file for the offline group:
This is only necessary if you installed a client with an installation policy that contains
shares that the client cannot access. The client remains in the installation state as the
recovery file cannot be uploaded to the share.
a. In the Users and Computers tab, right-click on the Offline Group and select
Advanced > Get Install Policy File.
b. Replace the installation policy located in the local Work folder on the client.
The Work folder with the policy is located in:
n
On x64 client:
%PROGRAMFILES(X86)%\CheckPoint\Endpoint
Security\Endpoint Common\Work\
n
On x86 client:
%PROGRAMFILES%\CheckPoint\Endpoint Security\Endpoint
Common\Work\
c. Reboot to continue the installation.
4.
Deploy the Packages
Instruct users to install the packages from the sub-paths. Make sure they have the
required access.