Cisco 2100 Series

4-18
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring 802.11n Parameters
Figure 4-3 802.11n (2.4 GHz) High Throughput Page
Step 2
Check the 11n Mode check box to enable 802.11n support on the network. The default value is enabled.
Step 3 To specify the modulation and coding scheme (MCS) rates at which data can be transmitted between the
access point and the client, check the check boxes of the desired rates. These data rates, which are
calculated for a 20-MHz channel width using a short guard interval, are available:
• 0 (7 Mbps)
• 1 (14 Mbps)
• 2 (21 Mbps)
• 3 (29 Mbps)
• 4 (43 Mbps)
• 5 (58 Mbps)
• 6 (65 Mbps)
• 7 (72 Mbps)
• 8 (14 Mbps)
• 9 (29 Mbps)
• 10 (43 Mbps)
• 11 (58 Mbps)
• 12 (87 Mbps)