7-22
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 7 Controlling Lightweight Access Points
Autonomous Access Points Converted to Lightweight Mode
Step 10 To view details about the access points that are provisioned using LSC, enter this command:
show certificate lsc ap-provision
Information similar to the following appears:
LSC AP-Provisioning........................... Yes
Provision-List................................ Present
Idx Mac Address
--- ------------
1 00:18:74:c7:c0:90
Using the GUI to Authorize Access Points
Using the controller GUI, follow these steps to authorize access points.
Step 1 Click Security > AAA > AP Policies to open the AP Policies page (see Figure 7-6).
Figure 7-6 AP Policies Page
Step 2
If you want the access point to accept self-signed certificates (SSCs), manufactured-installed certificates
(MICs), or local significant certificates (LSCs), check the appropriate check box.
Step 3 If you want the access points to be authorized using a AAA RADIUS server, check the Authorize MIC
APs against auth-list or AAA check box.
Step 4 If you want the access points to be authorized using an LSC, check the Authorize LSC APs against
auth-list check box.
Step 5 Click Apply to commit your changes.
Step 6 Follow these steps to add an access point to the controller’s authorization list:
a. Click Add to access the Add AP to Authorization List area.
b. In the MAC Address field, enter the MAC address of the access point.
To Next Page
Loading...
Need help?
General
