5-65
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 5 Configuring Security Solutions
Configuring and Applying Access Control Lists
Using the CLI to Apply Access Control Lists
Follow these steps to apply ACLs using the controller CLI.
Step 1 Perform any of the following:
• To apply an ACL to a management, AP-manager, or dynamic interface, enter this command:
config interface acl {management | ap-manager | dynamic_interface_name} acl_name
Note To see the ACL that is applied to an interface, enter show interface detailed {management
| ap-manager | dynamic_interface_name}. To remove an ACL that is applied to an interface,
enter config interface acl {management | ap-manager | dynamic_interface_name} none.
See Chapter 3 for more information on configuring controller interfaces.
• To apply an ACL to the data path, enter this command:
config acl apply acl_name
• To apply an ACL to the controller CPU to restrict the type of traffic (wired, wireless, or both)
reaching the CPU, enter this command:
config acl cpu acl_name {wired | wireless | both}
Note To see the ACL that is applied to the controller CPU, enter show acl cpu. To remove the
ACL that is applied to the controller CPU, enter config acl cpu none.
• To apply an ACL to a WLAN, enter this command:
config wlan acl wlan_id acl_name
Note To see the ACL that is applied to a WLAN, enter show wlan wlan_id. To remove the ACL
that is applied to a WLAN, enter config wlan acl wlan_id none.
• To apply a preauthentication ACL to a WLAN, enter this command:
config wlan security web-auth acl wlan_id acl_name
See Chapter 6 for more information on configuring WLANs.
Step 2 To save your settings, enter this command:
save config
To Next Page
Loading...
Need help?
General
