Name: Cisco 2100 Series
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

2-7

Cisco Wireless LAN Controller Configuration Guide

OL-17037-01

Chapter 2 Using the Web-Browser and CLI Interfaces

Using the CLI

Step 6 To confirm the current download settings and start the certificate and key download, enter this command

and answer y to the prompt:

transfer download start

Information similar to the following appears:

Mode........................................... TFTP

Data Type...................................... Site Cert

TFTP Server IP................................. xxx.xxx.xxx.xxx

TFTP Path...................................... directory path

TFTP Filename.................................. webadmincert_name

Are you sure you want to start? (y/n) y

TFTP Webadmin cert transfer starting.

Certificate installed.

Please restart the switch (reset system) to use the new certificate.

Step 7 To save the SSL certificate, key, and secure web password to NVRAM so that your changes are retained

across reboots, enter this command:

save config

Step 8 To reboot the controller, enter this command:

reset system

Using the CLI

The Cisco UWN Solution command line interface (CLI) is built into each controller. The CLI allows you

to use a VT-100 emulator to locally or remotely configure, monitor, and control individual controllers

and its associated lightweight access points. The CLI is a simple text-based, tree-structured interface that

allows up to five users with Telnet-capable terminal emulators to access the controller.

Note Refer to the Cisco Wireless LAN Controller Command Reference for information on specific commands.

Note If you want to input any strings from the XML configuration into CLI commands, you must enclose the

strings in quotation marks.

Logging into the CLI

You access the CLI using one of two methods:

• A direct ASCII serial connection to the controller console port

• A remote console session over Ethernet through the pre-configured service port or the distribution

system ports

Before you log into the CLI, configure your connectivity and environment variables based on the type

of connection you use.

Cisco 2100 Series Configuration Guide

Other manuals for Cisco 2100 Series