4-63
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring Voice and Video Parameters
Step 11 To configure the number of aggregated voice WMM traffic specification (TSPEC) streams at a specified
data rate for the 802.11a or 802.11b/g network, enter this command:
config {802.11a | 802.11b} cac voice stream-size number max-streams mean_datarate
The number range is 1 to 5 voice streams, and the default value is 2. The mean_datarate range is 84 to
91.2 Kbps, and the default value is 84 Kbps.
Step 12 To enable or disable expedited bandwidth requests for the 802.11a or 802.11b/g network, enter this
command:
config {802.11a | 802.11b} exp-bwreq {enable | disable}
Step 13 To enable or disable TSM for the 802.11a or 802.11b/g network, enter this command:
config {802.11a | 802.11b} tsm {enable | disable}
Step 14 To re-enable all WLANs with WMM enabled, enter this command:
config wlan enable wlan_id
Step 15 To re-enable the radio network, enter this command:
config {802.11a | 802.11b} enable network
Step 16 To save your settings, enter this command:
save config
Using the CLI to Configure Video Parameters
Follow these steps to configure video parameters using the CLI.
Step 1 To see all of the WLANs configured on the controller, enter this command:
show wlan summary
Step 2 To make sure that the WLAN you are planning to modify is configured for WMM and the QoS level is
set to Gold, enter this command:
show wlan wlan_id
Step 3 To disable all WLANs with WMM enabled prior to changing the video parameters, enter this command:
config wlan disable wlan_id
Step 4 To disable the radio network, enter this command:
config {802.11a | 802.11b} disable network
Step 5 To save your settings, enter this command:
save config
Step 6 To enable or disable video CAC for the 802.11a or 802.11b/g network, enter this command:
config {802.11a | 802.11b} cac video acm {enable | disable}
To Next Page
Loading...
Need help?
General
