Cisco 2100 Series Configuration Guide

10-9
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 10 Managing User Accounts
Choosing the Web Authentication Login Page
Figure 10-9 Successful Login Page
The default successful login page contains a pointer to a virtual gateway address URL:
https://1.1.1.1/logout.html. The IP address that you set for the controller virtual interface serves as the
redirect address for the login page (see Chapter 3 for more information on the virtual interface).
Choosing the Web Authentication Login Page
This section provides instructions for specifying the content and appearance of the web authentication
login page. Follow the instructions in one of these sections to choose the web authentication login page
using the controller GUI or CLI:
• Choosing the Default Web Authentication Login Page, page 10-10
• Creating a Customized Web Authentication Login Page, page 10-14
• Using a Customized Web Authentication Login Page from an External Web Server, page 10-16
• Downloading a Customized Web Authentication Login Page, page 10-17
• Assigning Login, Login Failure, and Logout Pages per WLAN, page 10-21
Note If you do not want users to connect to a web page using a browser that is configured with SSLv2 only,
you can disable SSLv2 for web authentication by entering this command: config network secureweb
cipher-option sslv2 disable. If you enter this command, users must use a browser that is configured to
use a more secure protocol such as SSLv3 or later. The default value is enabled.

Cisco 2100 Series Specifications

General

Power over Ethernet (PoE)	No
Form Factor	Desktop
Encryption	AES, TKIP
Maximum Access Points	6
Security	WPA, WPA2, 802.1X
Dimensions	1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)