Cisco 2100 Series Configuration Guide

CHAPTER
7-1
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
7
Controlling Lightweight Access Points
This chapter describes the Cisco lightweight access points and explains how to connect them to the
controller and manage access point settings. It contains these sections:
• Access Point Communication Protocols, page 7-2
• Configuring Global Credentials for Access Points, page 7-5
• Configuring Authentication for Access Points, page 7-9
• Embedded Access Points, page 7-14
• Autonomous Access Points Converted to Lightweight Mode, page 7-16
• Cisco Workgroup Bridges, page 7-34
• Configuring Backup Controllers, page 7-41
• Configuring Failover Priority for Access Points, page 7-46
• Configuring Country Codes, page 7-49
• Migrating Access Points from the -J Regulatory Domain to the -U Regulatory Domain, page 7-55
• Using the W56 Band in Japan, page 7-58
• Dynamic Frequency Selection, page 7-58
• Optimizing RFID Tracking on Access Points, page 7-59
• Configuring Probe Request Forwarding, page 7-62
• Retrieving the Unique Device Identifier on Controllers and Access Points, page 7-63
• Performing a Link Test, page 7-64
• Configuring Link Latency, page 7-67
• Configuring Power over Ethernet, page 7-70
• Configuring Flashing LEDs, page 7-74
• Viewing Clients, page 7-74

Cisco 2100 Series Specifications

General

Power over Ethernet (PoE)	No
Form Factor	Desktop
Encryption	AES, TKIP
Maximum Access Points	6
Security	WPA, WPA2, 802.1X
Dimensions	1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)