Cisco 2100 Series Configuration Guide

11-7
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 11 Configuring Radio Resource ManagementWireless Device Access
Configuring an RF Group
Using the GUI to Configure an RF Group
Follow these steps to create an RF group using the GUI.
Step 1 Click Controller > General to open the General page (see Figure 11-1).
Figure 11-1 General Page
Step 2
Enter a name for the RF group in the RF-Network Name field. The name can contain up to 19 ASCII
characters.
Step 3 Click Apply to commit your changes.
Step 4 Click Save Configuration to save your changes.
Step 5 Repeat this procedure for each controller that you want to include in the RF group.
Using the CLI to Configure RF Groups
Follow these steps to configure an RF group using the CLI.
Step 1 Enter config network rf-network-name name to create an RF group.
Note Enter up to 19 ASCII characters for the group name.
Step 2 Enter show network to view the RF group.

Cisco 2100 Series Specifications

General

Power over Ethernet (PoE)	No
Form Factor	Desktop
Encryption	AES, TKIP
Maximum Access Points	6
Security	WPA, WPA2, 802.1X
Dimensions	1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)