EasyManuals Logo

Cisco 2100 Series Configuration Guide

Cisco 2100 Series
796 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
2-9
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 2 Using the Web-Browser and CLI Interfaces
Enabling Wireless Connections to the Web-Browser and CLI Interfaces
Logging Out of the CLI
When you finish using the CLI, navigate to the root level and enter logout. The system prompts you to
save any changes you made to the volatile RAM.
Navigating the CLI
The CLI is organized around five levels:
Root Level
Level 2
Level 3
Level 4
Level 5
When you log into the CLI, you are at the root level. From the root level, you can enter any full command
without first navigating to the correct command level. Table 2-1 lists commands you use to navigate the
CLI and to perform common tasks.
Enabling Wireless Connections to the Web-Browser and
CLI Interfaces
You can monitor and configure controllers using a wireless client. This feature is supported for all
management tasks except uploads from and downloads to the controller.
Before you can open the GUI or the CLI from a wireless client device, you must configure the controller
to allow the connection. Follow these steps to enable wireless connections to the GUI or CLI.
Step 1 Log into the CLI.
Step 2 Enter config network mgmt-via-wireless enable.
Table 2-1 Commands for CLI Navigation and Common Tasks
Command Action
help At the root level, view systemwide navigation
commands
? View commands available at the current level
command ? View parameters for a specific command
exit Move down one level
Ctrl-Z Return from any level to the root level
save config At the root level, save configuration changes from
active working RAM to non-volatile RAM
(NVRAM) so they are retained after reboot
reset system At the root level, reset the controller without
logging out

Table of Contents

Other manuals for Cisco 2100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 2100 Series and is the answer not in the manual?

Cisco 2100 Series Specifications

General IconGeneral
Power over Ethernet (PoE)No
Form FactorDesktop
EncryptionAES, TKIP
Maximum Access Points6
SecurityWPA, WPA2, 802.1X
Dimensions1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)

Related product manuals