13-7
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 13 Configuring Hybrid REAPWireless Device Access
Configuring Hybrid REAP
Using the GUI to Configure the Controller for Hybrid REAP
The controller configuration for hybrid REAP consists of creating centrally switched and locally
switched WLANs. Follow the steps in this section to use the GUI to configure the controller for these
WLANs. This procedure uses these three WLANs as examples:
Note See the “Using the CLI to Configure the Controller for Hybrid REAP” section on page 13-11 if you
would prefer to configure the controller for hybrid REAP using the CLI.
Step 1 Follow these steps to create a centrally switched WLAN. In our example, this is the first WLAN
(employee).
a. Click WLANs to open the WLANs page.
b. Choose Create New from the drop-down box and click Go to open the WLANs > New page (see
Figure 13-2).
Figure 13-2 WLANs > New Page
c.
From the Type drop-down box, choose WLAN.
d. Enter a unique profile name for the WLAN in the Profile Name field.
e. Enter a name for the WLAN in the WLAN SSID field.
f. From the WLAN ID drop-down box, choose the ID number for this WLAN.
g. Click Apply to commit your changes. The WLANs > Edit page appears (see Figure 13-3).
WLAN Security Switching Interface Mapping (VLAN)
employee WPA1+WPA2 Central management (centrally switched
VLAN)
employee-local WPA1+WPA2 (PSK) Local 101 (locally switched VLAN)
guest-central Web authentication Central management (centrally switched
VLAN)
To Next Page
Loading...
Need help?
General
