EasyManuals Logo

Cisco 2100 Series Configuration Guide

Cisco 2100 Series
796 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #161 background imageLoading...
Page #161 background image
4-65
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring Voice and Video Parameters
Total Num of exp bw requests received.......... 5
Total Num of exp bw requests admitted....... 2
Num of voice calls rejected since AP joined.... 0
Num of roam calls rejected since AP joined..... 0
Num of calls rejected due to insufficient bw....0
Num of calls rejected due to invalid params.... 0
Num of calls rejected due to PHY rate.......... 0
Num of calls rejected due to QoS policy........ 0
In the example above, “MT” is medium time, “Na” is the number of additional calls, and “exp bw”
is expedited bandwidth.
3. To see the U-APSD status for a particular client, enter this command:
show client detail client_mac
4. To see the TSM statistics for a particular client and the access point to which this client is associated,
enter this command:
show client tsm {802.11a | 802.11b} client_mac [ap_mac | all]
The optional all command shows all access points to which this client has associated. Information
similar to the following appears:
AP Interface Mac: 00:0b:85:01:02:03
Client Interface Mac: 00:01:02:03:04:05
Measurement Duration: 90 seconds
Timestamp 1st Jan 2006, 06:35:80
UpLink Stats
================
Average Delay (5sec intervals)............................35
Delay less than 10 ms.....................................20
Delay bet 10 - 20 ms......................................20
Delay bet 20 - 40 ms......................................20
Delay greater than 40 ms..................................20
Total packet Count.........................................80
Total packet lost count (5sec).............................10
Maximum Lost Packet count(5sec)............................5
Average Lost Packet count(5secs)...........................2
DownLink Stats
================
Average Delay (5sec intervals)............................35
Delay less than 10 ms.....................................20
Delay bet 10 - 20 ms......................................20
Delay bet 20 - 40 ms......................................20
Delay greater than 40 ms..................................20
Total packet Count.........................................80
Total packet lost count (5sec).............................10
Maximum Lost Packet count(5sec)............................5
Average Lost Packet count(5secs)...........................2
Note The statistics are shown in 90-second intervals. The timestamp field shows the specific
interval when the statistics were collected.

Table of Contents

Other manuals for Cisco 2100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 2100 Series and is the answer not in the manual?

Cisco 2100 Series Specifications

General IconGeneral
Power over Ethernet (PoE)No
Form FactorDesktop
EncryptionAES, TKIP
Maximum Access Points6
SecurityWPA, WPA2, 802.1X
Dimensions1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)

Related product manuals