Cisco 2100 Series Configuration Guide

4-70
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring Cisco Discovery Protocol
• An access point connected directly to a 2100 series controller
This support enables network management applications to discover Cisco devices.
These TLVs are supported by both the controller and the access point:
• Device-ID TLV: 0x0001—The host name of the controller, the access point, or the CDP neighbor.
• Address TLV: 0x0002—The IP address of the controller, the access point, or the CDP neighbor.
• Port-ID TLV: 0x0003—The name of the interface on which CDP packets are sent out.
• Capabilities TLV: 0x0004—The capabilities of the device. The controller sends out this TLV with
a value of Host: 0x10, and the access point sends out this TLV with a value of Transparent Bridge:
0x02.

Cisco 2100 Series Specifications

General

Power over Ethernet (PoE)	No
Form Factor	Desktop
Encryption	AES, TKIP
Maximum Access Points	6
Security	WPA, WPA2, 802.1X
Dimensions	1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)