Cisco 2100 Series Configuration Guide

5-100
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 5 Configuring Security Solutions
Managing Rogue Devices
6. To see the rogue report (which shows the number of rogue devices detected on different channel
widths) for a specific 802.11a/n radio, enter this command:
show ap auto-rf 802.11a Cisco_AP
Information similar to the following appears:
Number Of Slots.................................. 2
AP Name.......................................... AP2
MAC Address...................................... 00:1b:d5:13:39:74
Radio Type..................................... RADIO_TYPE_80211a
Noise Information
Noise Profile................................ PASSED
Channel 36................................... -80 dBm
Channel 40................................... -78 dBm
...
Interference Information
Interference Profile......................... PASSED
Channel 36................................... -81 dBm @ 8 % busy
Channel 40................................... -66 dBm @ 4 % busy
...
Rogue Histogram (20/40_ABOVE/40_BELOW)
Channel 36................................... 21/ 1/ 0
Channel 40................................... 7/ 0/ 0
...
7. To view a list of all rogue clients that are associated to a rogue access point, enter this command:
show rogue ap clients ap_mac_address
Information similar to the following appears:
MAC Address State # APs Last Heard
----------------- ------------------ ----- -------------------------
00:bb:cd:12:ab:ff Alert 1 Fri Nov 30 11:26:23 2007
8. To view a list of all rogue clients detected by the controller, enter this command:
show rogue client summary
Information similar to the following appears:
Validate rogue clients against AAA............... Disabled
MAC Address State # APs Last Heard
----------------- ------------------ ----- -----------------------
00:0a:8a:7d:f5:f5 Alert 1 Mon Dec 3 21:56:36 2007
00:18:ba:78:c4:44 Alert 1 Mon Dec 3 21:59:36 2007
00:18:ba:78:c4:d1 Alert 1 Mon Dec 3 21:47:36 2007
00:18:ba:78:ca:f8 Alert 1 Mon Dec 3 22:02:36 2007
...
9. To view detailed information for a specific rogue client, enter this command:
show rogue client detailed client_mac_address
Information similar to the following appears:
Rogue BSSID...................................... 00:0b:85:23:ea:d1
State............................................ Alert
First Time Rogue was Reported.................... Mon Dec 3 21:50:36 2007
Last Time Rogue was Reported..................... Mon Dec 3 21:50:36 2007
Rogue Client IP address.......................... Not known
Reported By
AP 1
MAC Address.............................. 00:15:c7:82:b6:b0
Name..................................... AP0016.47b2.31ea

Cisco 2100 Series Specifications

General

Power over Ethernet (PoE)	No
Form Factor	Desktop
Encryption	AES, TKIP
Maximum Access Points	6
Security	WPA, WPA2, 802.1X
Dimensions	1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)