Cisco 2100 Series Configuration Guide

5-121
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 5 Configuring Security Solutions
Configuring wIPS
1. To view the wIPS submode on the access point, enter this command:
show ap config general Cisco_AP
Information similar to the following appears:
Cisco AP Identifier.............................. 3
Cisco AP Name.................................... AP1131:46f2.98ac
...
AP Mode ......................................... Monitor
Public Safety ................................... Disabled Disabled
AP SubMode ...................................... WIPS
...
2. To see the wIPS optimized channel scanning configuration on the access point, enter this command:
show ap monitor-mode summary
Information similar to the following appears:
AP Name Ethernet MAC Status Scanning Channel List
------------------ -------------------- ---------- ------------------------
AP1131:46f2.98ac 00:16:46:f2:98:ac wIPS 1, 6, NA, NA
3. To view the wIPS configuration forwarded by WCS to the controller, enter this command:
show wps wips summary
Information similar to the following appears:
Policy Name.............. Default
Policy Version.......... 3
4. To view the current state of wIPS operation on the controller, enter this command:
show wps wips statistics
Information similar to the following appears:
Policy Assignment Requests............ 1
Policy Assignment Responses........... 1
Policy Update Requests................ 0
Policy Update Responses............... 0
Policy Delete Requests................ 0
Policy Delete Responses............... 0
Alarm Updates......................... 13572
Device Updates........................ 8376
Device Update Requests................ 0
Device Update Responses............... 0
Forensic Updates...................... 1001
Invalid WIPS Payloads................. 0
Invalid Messages Received............. 0
NMSP Transmitted Packets.............. 22950
NMSP Transmit Packets Dropped......... 0
NMSP Largest Packet................... 1377
5. To clear the wIPS statistics on the controller, enter this command:
clear stats wps wips

Cisco 2100 Series Specifications

General

Power over Ethernet (PoE)	No
Form Factor	Desktop
Encryption	AES, TKIP
Maximum Access Points	6
Security	WPA, WPA2, 802.1X
Dimensions	1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)