EasyManuals Logo

Cisco 2100 Series Configuration Guide

Cisco 2100 Series
796 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #720 background imageLoading...
Page #720 background image
D-4
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Appendix D Troubleshooting
System Messages
ROGUE_AP_REMOVED Detected rogue access point has timed out. The
unit might have shut down or moved out of the
coverage area.
AP_MAX_ROGUE_COUNT_EXCEEDED The current number of active rogue access points
has exceeded system threshold.
LINK_UP Positive confirmation message.
LINK_DOWN Port may have a problem or is administratively
disabled.
LINK_FAILURE Port may have a problem or is administratively
disabled.
AUTHENTICATION_FAILURE Attempted security breech. Investigate.
STP_NEWROOT Informational message.
STP_TOPOLOGY_CHANGE Informational message.
IPSEC_ESP_AUTH_FAILURE Check WLAN IPSec configuration.
IPSEC_ESP_REPLAY_FAILURE Check for attempt to spoof IP Address.
IPSEC_ESP_POLICY_FAILURE Check for IPSec configuration mismatch between
WLAN and client.
IPSEC_ESP_INVALID_SPI Informational message.
IPSEC_OTHER_POLICY_FAILURE Check for IPSec configuration mismatch between
WLAN and client.
IPSEC_IKE_NEG_FAILURE Check for IPSec IKE configuration mismatch
between WLAN and client.
IPSEC_SUITE_NEG_FAILURE Check for IPSec IKE configuration mismatch
between WLAN and client.
IPSEC_INVALID_COOKIE Informational message.
RADIOS_EXCEEDED Maximum number of supported Cisco radios
exceeded. Check for controller failure in the same
Layer 2 network or add another controller.
SENSED_TEMPERATURE_HIGH Check fan, air conditioning and/or other cooling
arrangements.
SENSED_TEMPERATURE_LOW Check room temperature and/or other reasons for
low temperature.
TEMPERATURE_SENSOR_FAILURE Replace temperature sensor ASAP.
TEMPERATURE_SENSOR_CLEAR Temperature sensor is operational.
POE_CONTROLLER_FAILURE Check ports — possible serious failure detected.
MAX_ROGUE_COUNT_EXCEEDED The current number of active rogue access points
has exceeded system threshold.
SWITCH_UP Controller is responding to SNMP polls.
SWITCH_DOWN Controller is not responding to SNMP polls, check
controller and SNMP settings.
Table D-1 System Messages and Descriptions (continued)
Error Message Description

Table of Contents

Other manuals for Cisco 2100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 2100 Series and is the answer not in the manual?

Cisco 2100 Series Specifications

General IconGeneral
Power over Ethernet (PoE)No
Form FactorDesktop
EncryptionAES, TKIP
Maximum Access Points6
SecurityWPA, WPA2, 802.1X
Dimensions1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)

Related product manuals